Filter
Top Products
34
PIP
213
546
879
0
TV
SWAP PIP CH
DN
UP
FREEZE
SOUND
MUTE
SURF
A/CH
POWER
PICTURE
STATUS/
EXIT
POSITION
VCR
ACC
MENU/
SELECT
VOL
CH
TV/VCR
ACTIVE
CONTROL
1
6
2,4
3,5
SOUND
BALANCE
AVL
INCR
.
SURROUND
HEADPHONE
STEREO MONO
STEREO STEREO
PICTURE
SOUND
FEATURES
INSTALL
TREBLE
BASS
BALANCE
AVL
INCR
.
SURROUND
TREBLE 30
BASS
BALANCE
AVL
INCR
.
SURROUND
SOUND
OR
SELECTING THE S
TEREO/MONO SOUND MODE
Y
ou can enjoy stereo programs on your
TV. It has both an amplifier and twin
speakers through which stereo sound can be
heard. While watching the channel or signal
source for which you want to select
STEREO, follow the steps below.
NOTE: When you connect a mono (non-
stereo) device to the TV, such as a mono
VCR, you must be sure to select MONO for
the AV source to which you connected the
device. Otherwise, you will receive sound
from only one speaker. The reason is that in
connecting the mono device, you can use
only one audio input (Left or Right channel).
This will produce sound in only one speaker
when the sound setting for the AV source is
STEREO.
1
Press the MENU/SELECT button
on the remote control to show the
onscreen menu.
2
Press the CURSOR RING DOWN
once to highlight SOUND.
3
Press the CURSOR RING RIGHT
to enter the SOUND submenu.
4
Press the CURSOR RING DOWN
repeatedly until the STEREO control
is highlighted.
5
Press the CURSOR RING RIGHT
or LEFT to select STEREO or
MONO. When STEREO has been
selected, the television will reproduce
any stereo signal it receives.
6
Press the STATUS/EXIT button to
exit the menu.
BEGIN
Using the Onscreen Submenus: Sound