Filter
Top Products
Philips Electronics Singapore Software Upgrade Instruction
7 Steps to Upgrade Software
1. Burn the files to blank CD-R or CD-RW, not a DVD, using the following
settings:
• File System CD-ROM ISO Level 2
• Mode 1/2/XA
• Character set ISO 9660
• Finalized, single session
• Write speed slow (e.g. 2x, 4x)
Finalize the disc. (The application may do this automatically.)
NOTE: Packet writing application for drag & drop copying cannot be used
for creating an upgrade disc. Use only a dedicated CD writing application
allowing ‘disc at once’ recording.
No UDF setting as well.
2. Power on the set
3. Put in the disc
4. A message will be displayed on the OSD after the upgrade file is recognized
5. Follow the instruction displayed on the TV Screen – Press “OK” to upgrade
6. After reading the file, the disc will be ejected
7. Remove the disc, but DO NOT close the tray
8. Wait approximately 3-5 minutes for the software to be upgraded
9. The set will restart itself once the upgrade is completed.
Caution: Do not unplug or power off the set while upgrading in
progress.
8 After the upgrade
Do check the Software Version to confirm the upgrade.
Please follow the procedure described in the Section 4.
9 Software History
Software Version Number 00.05.01.0D
• Fix the problem of the Player switches on from Standby by itself.
Prepared by Ivan Chan 4 of 4