Filter
Top Products
Software upgrade
How to upgrade the software
1) Burn the data onto a blank CD-R or RW disc.
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with
the following display TV screen:
Loading
Firmware Upgrade Erase and program.
Select OK to start upgrade.
3) Press <OK> button to confirm, then screen will
display :
Firmware Upgrade Programming, Please Wait...
Do not Switch the Player Off !
4) The upgraded disc will automatically out when
files coping complete, then take out the disc.
5) About 1 minute later, the tray will automatically
close when upgrading complete.
B. Read out the Firmware version to confirm the
upgrading
1) Power on the set and Open the tray door.
2) Press <9><6><6>button to check the software
information.
The software version and other information are
display on the TV screen as follows:
BE Version: DVP33XX_XX.XX
FE Version: XXXX.XXXXXX
DSP Version: DSP.XX
Region Code: X
4-1
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
OK Cancel
Region Code Change
1) Power on the set and open the tray door;
2) Press "9" "8" "7" "9" and press the region
code number (0-6) on the remote control.
Notes:restart after above steps.