Philips DVP3336X/94 DVD Player User Manual


  Open as PDF
of 32
 
21
[Sound Mode]
Select a preset sound effect to enhance the
audio output.
 [3D] - Select a virtual surround sound
effect that is produced from the left and
right audio channels.
 [Movie Mode] - Select a sound effect for
movies.
 [Music Mode] - Select a sound effect for
music.
[Speaker Setup]
Optimizes surround output for the connected
speakers system.
 [Front Speaker]
Option Description
[Large] Produces low frequency signal
below 120 Hz.
[Small] Cannot produce low frequency
signal below 120 Hz.
 [Centre Speaker] / [Rear Speaker]
Option Description
[Large] Produces low frequency signal
below 120 Hz.
[Small] Cannot produce low
frequency signal below 120 Hz.
[Off] No speaker is connected.
 [Subwoofer]
Option Description
[On] A subwoofer is connected.
[Off] No subwoofer is
connected.
 [Speakers Volume] – Sets the volume
level of each speaker to get the ideal
audio balance.
1 Press OK.
2 Select a speaker, then press to adjust
the volume.
4 Select a setting, then press OK.
To return to the previous menu, 
press
.
To exit the menu, press  SETUP.
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
 [Stereo] - For stereo output.
 [LT/RT] - For surround sound output
through two speakers.
 [V SURR] - For analogue surround sound
output from the main speaker.
 [Multi Channel] - For surround sound
output through 5.1 channel receiver.
[Digital Audio]
Select a digital setting based on the digital
DPSOLÀHUUHFHLYHUWKDWLVFRQQHFWHGWKURXJK
the digital jack (coaxial/digital).
 [Digital Output] - Select a type of digital
output.
 [Off] - Disable digital output.
 [All] - Support multi-channel audio
formats.
 [PCM Only] - Downmix to two-
channel audio format.
 [LPCM Output] - Select the LPCM
(Linear Pulse Code Modulation) output
sampling rate.
 [48kHz] - For discs recorded at
sampling rate of 48 kHz.
 [96kHz] - For discs recorded at
sampling rate of 96 kHz.
Note
[LPCM Output] setting is only available if the
[Digital Output] is set to [PCM Only].
The higher the sampling rate, the better the
sound quality.
[Volume]
Set the default volume level when you play a
disc.
1. Press OK.
2. Press
to set the volume.
3. Press OKWRFRQÀUPDQGH[LW
English
EN
 previous next