Filter
Top Products
28
[ Center Speaker/Rear Speakers ]•
Option Description
[ Large ] Produce low frequency
signal below 120 Hz.
[ Small ] Cannot produce low
frequency signal below
120 Hz.
[ Off ] No speaker is
connected.
[ Subwoofer ]•
Option Description
[ On ] A subwoofer is
connected.
[ Off ] No subwoofer is
connected.
[ Speakers Volume ]• – Set the volume
level of each speaker to get the ideal
audio balance.
Press 1. OK.
Select a speaker, then press 2. b B to
adjust the volume.
Press 3. OK to conÀ rm and exit.
[ Speakers Delay ]• – Set the delay time
for the center, subwoofer and rear
speakers if they are placed closer to the
listening position, so that the sound
output from all speakers reach the
listening position at the same time.
Press 1. OK.
Select a speaker, then press 2. b B to
set the delay time.
Press 3. OK to conÀ rm and exit.
Note
[ Speaker Setup ]• setting is only available if you have
set the [ Analog Output ] setting to [ Multi Channel ].
[ CD Upsampling ]
For better sound quality in stereo mode,
convert the music CD to a higher sampling
rate.
[ Off ]• – turn off CD-upsampling.
[ 88.2kHz ]• – convert to twice the
original sampling rate.
[ 176.4kHz ]• – convert to four times
the original sampling rate.
[ Night Mode ]
You can play DVDs with Dolby Digital
mode at a low volume, without disturbing
others. High volume output is decreased
and low volume output is increased to an
audible level.
[ On ]• – turn on night mode.
[ Off ]• – enjoy surround sound with its
full dynamic range.