Philips DVP 3100V DVD Player User Manual


 
English
23
Operation with tape (Continued)
ShowView Programming
ShowView greatly simplifies entering the date, channel,
start and end times of a Timer Recording by simply
entering a ShowView Code. ShowView Codes are
published in most TV guide magazines; they can vary one
to nine numbers in length.
1
Make sure that TV channels have been tuned.
Insert a video cassette with protection tab into your
VCR.
2
Press SHOWVIEW.
3
Press the numbered buttons to enter the
ShowView Code of the TV programme that you wish
to record.
If you make a mistake press 1 then enter the revised
number.
4
Press OK.
If PLEASE CHECK is displayed it means that you have
entered the wrong ShowView number, entered the
ShowView number incorrectly.
If “- -” is displayed, you have to enter the programme
number of the station, you want to record from.
5
Press 1 or 2 to select the settings that you wish to
revise. (PR, DATE,TIME and SP).
Press 3 or 4 to enter the correct information.
6
Press 3 or 4 to switch VPS/PDC on or off.
Press 2 to select the recording speed.
Press 3 or 4 to select the desired tape speed (SP, IP, or
LP).
IP mode determines how much tape is left and switches
speed from SP to LP, if necessary, to complete recording
the program.
IP mode cannot be selected when VPS/PDC is ON.
Check that the timer event details are correct.
If you wish to record from AUDIO IN and VIDEO IN on
the front or from either of the EURO SCART sockets on
the back of VCR, press INPUT to select for correct
display (AV1,AV2 or AV3).
7
If you want to make another ShowView recording
repeat stages 2 - 6.
Press SYSTEM MENU twice.
If PLEASE CHECK is displayed, you have entered
incorrect information and will need to re-enter the data.
Press
11
to switch your VCR power off mode.
will appear in the video recorder’s display while
your VCR waits to make the recording.
To watch a DVD during timer recording standby mode,
press POWER and DVD to switch to DVD mode.
8
Press POWER to end recording.
Notes
Video Programme System (VPS)
The Video Programme System (VPS) ensures that the TV
programmes that you have programmed for timer
recording will be recorded exactly from their beginning to
end, even if the actual broadcasting time differs from the
scheduled time due to delayed start, or if the programme
is extended beyond its scheduled time.Also, if a
programme is interrupted, for example, if a news flash is
inserted, the recording will also be interrupted
automatically and resumed when the programme
continues.
The VPS signal is broadcast by the TV station and this
controls the timer in the video recorder.
VPS should be set ON for all timer recordings from TV
stations broadcasting these signals. It should be set OFF
for all timer recordings from TV stations that are not
broadcasting these signals.
*** The similar system PDC, which is used in the time
being in the Netherlands, can also be used with your new
video recorder.
OK
i
0~9,
SHOWVIEW NO.
246876543
REC
DELETE :
OK
i
0~9,
SHOWVIEW NO.
- - - - - - - - -
REC