Filter
Top Products
18
English
AUDIO IN
WIRELESS
TRANSMITTER
1
2
Step 7: Connecting the
power cord
After everything is connected
properly, connect the AC power
cord into the power outlet.
The standby LED on the main unit lights
up.
The wireless indicator “ “ on the
wireless transmitter and receiver light up.
Note:
Turning off to standby mode does not
disconnect the unit from mains.
Helpful Hints:
– Refer to the type plate at the rear or
bottom of the product for identi cation and
supply ratings.
– Before making or changing any
connections, make sure that all the devices
are disconnected from the power outlet.
Basic Connections (continued)
Step 6: Connecting the
FM and AM/MW
antennas
A Connect the supplied AM/MW loop
antenna to the AM/MW socket. Place
the AM/MW loop antenna on a shelf, or
attach it to a stand or wall.
B Connect the supplied FM antenna to the
FM 75 Ω socket. Extend the FM antenna
and x its ends to the wall.
For better FM stereo reception, connect
an external FM antenna (not supplied).
Helpful Hints:
– Adjust the position of the antennas for
optimal reception.
– Position the antennas as far away as
possible from your TV, VCR or other
radiation source to prevent any unwanted
interference.
FM
antenna
AM/MW antenna
x the claw
into the slot
AUDIO IN
WIRELESS
TRANSMITTER