Filter
Top Products
English
35
Clock/Timer
Viewing clock
● The clock (if it is set) is shown in normal standby
mode.
To view the clock in any sound source
(CD or FM for example )
● Press briefly DISPLAY/CLOCK (or CLOCK
on the remote control ).
Setting clock
1 In standby mode, press and hold DISPLAY/
CLOCK.
➜ The clock digits flash on the display panel.
➜ If the clock has not been set, "00: 00" flashes
2 Press TUNING à / á (or à / á on the
remote) to set the hours.
3 Press í/
ë to set the minutes.
4 Press PROG to select between 12 hour and 24
hour display.
5 Press DISPLAY/CLOCK agian to store the
setting.
➜ The clock starts working.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 90 seconds.
–To exit clock setting without storing, press STOP
on the system to exit.
Setting wake-up timer
The system can switch on to DISC, TUNER or
USB mode automatically at a preset time, serving
as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
–To set a new timer, you need to
deactivate the previously set timer.
1 In standby mode, press and hold SLEEP/
TIMER on the remote for more than 2 seconds
to enter timer setting mode.
➜ The source and timer digits will be lighted on
the display panel.
➜ “ 00: 00 “ will be displayed briefly if wake-up
timer is not set.
2 Press DISC, USB or TUNER to select the
desired source.
● Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
TUNER – tune to the desired radio station.
USB – connect a USB device.
3 Press TUNING à / á (or à / á on the
remote) to set the hours.
4 Press í/
ë to set the minutes.
5 Press SLEEP/TIMER to store the time.
● At the preset time, the selected source will play.
To deactivate the wake-up timer
● In standby mode, press SLEEP/TIMER until
“TIMER OFF” is displayed on the panel.
Notes:
– The system will exit timer setting mode if no
button is pressed within 90 seconds.
– Display shows if activated, and disappears if
deactivated.
Setting sleep timer
The sleep timer enables the system to switch off
by itself after a set period of time.
1 During playback, press SLEEP/TIMER on the
remote control repeatedly to select sleep
options.
➜ The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ 90 ™120 ™ OFF
2 Press SLEEP/TIMER until you reach the
desired length of time.
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until "OFF" is
displayed, or press the STANDBY ON y
button.
pg021-039_MCD177_12_Eng 2/4/09, 15:4935