Filter
Top Products
15
Set clock
1
In the standby mode, press and hold
CLOCK to activate the clock setting
mode.
The hour digits are displayed and begin »
to blink.
2 Press + VOL - to set the hour.
The minute digits are displayed and »
begin to blink.
3 Press + VOL - to set the minute.
4 Press CLOCK to confi rm the clock setting.
Turn on
1
Press .
The unit switches to the last selected »
source.
Switch to standby mode
1 Press again.
The clock (if set) appears on the »
display panel.
Find the correct viewing
channel
1
Press to turn on the unit.
2 Press DISC to switch to disc mode.
3 Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
Go to the lowest channel on your TV, •
then press the Channel Down button
until you see the Philips screen.
Press the source button repeatedly on •
the remote control of your TV.
4 Get started
Caution
Use of controls or adjustments or performance of •
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
bottom of the apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat, •
sunshine or fi re. Never discard batteries in fi re.
For fi rst-time use:
1 Remove the protective tab to activate the
remote control battery.
To replace the remote control batteries:
1 Open the battery compartment.
2 Insert one lithium CR2025 battery with
correct polarity (+/-) as indicated.
3 Close the battery compartment.
Note
Before you press any function button on the remote •
control, fi rst select the correct source with the remote
control.
If you are not going to use the remote control for a
•
long time, remove the battery.
English
EN