Filter
Top Products
27
English
Radio Reception
DISPLAY/ST
Tuning to radio stations
1 Press SOURCE on the set or TUNER on the
remote repeatedly until the desired waveband
(FM or MW) is displayed.
2 Press down on TUNING 22/33 and
release the button.
➜ The radio automatically tunes to a station
with sufficient reception.
3 Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press TUNING
22/33 briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 20 radio stations
for each band in the memory.
Manual programming
1 Tune to your desired station (refer to “Tuning to
radio stations”).
2 Press PROGRAM to activate programming.
➜ PROG flashes on the display.
3 Press PRESETí/ë to allocate a number
from 1 to 20 to this station.
4 Press PROGRAM again to confirm the setting.
➜ PROG disappears.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press PRESETí/ë until the desired preset
station is displayed.
Changing tuning grid (not available
for all versions)
In North and South America, the frequency step
between adjacent channels in the MW band is
10 kHz (9 kHz in some areas). The preset
frequency step in the factory is 9 kHz.
IMPORTANT!
Changing the tuning grid will erase all
previously stored preset radio stations.
1 Disconnect the system from the AC power
supply (pull out the AC power cord).
2 While holding down SOURCE and PLAY/
PAUSE 2; on the main unit, reconnect the
system to the AC power supply.
➜ The display will show “GRID 9” or “GRID
10”.
Note:
– GRID 9 and GRID 10 indicate that the tuning
grid is in step of 9 kHz and 10 kHz respectively.
pg001-pg035_MCD190_21-Eng 2005.7.27, 11:2527