Filter
Top Products
33
English
Clock/Timer
Clock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
● The system can be used as an alarm clock,
whereby DISC or TUNER is switched on at a set
time (one time operation). The clock time needs
to be set first before the timer can be used.
1 In standby mode, press and hold SLEEP/
TIMER on the remote control for more than
three seconds.
➜ "SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2 Pressí/ë on the front panel or on the
remote control to set the hours and press
SLEEP/TIMER to confirm.
➜ The minute digits flash on the display panel.
3 Pressí/ë on the front panel or on the
remote control to set the minutes and press
SLEEP/TIMER to confirm.
4 In standby mode, press TIMER on the remote
control to activate or deactivate the timer.
➜ Display shows if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1 In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜ The selections are as follows (time in
minutes):
SLEEP OFF ™ SLEEP 90 ™ SLEEP 80 ™
SLEEP 70 ™ SLEEP 60 ™ SLEEP 50 ™
SLEEP 40 ™ SLEEP 30 ™ SLEEP 20 ™
SLEEP 10™ SLEEP OFF
2 When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until "SLEEP
OFF" is displayed, or press STANDBY ON y
(or y on the remote).
CLOCK
VOLUME
+
-
STANDBY
-
ON
MICRO THEATRE MCD196
PRESET
SOURCE
TUNING
DBB
DSC
AUX
DISPLAY/CLOCK SET
iR
pg001-pg037_MCD196-98-Eng 30/1/07, 16:4033