Philips MCD288 CRT Television User Manual


  Open as PDF
of 4
 
1
2
3
4
In standby mode, press and hold CLOCK on the remote.
When the hour digits flash, press VOLUME-/+ (VOL+/- on the remote) to set the hours.
Press CLOCK again and the minute digits flash. Then press VOLUME-/+ (VOL+/- on the
remote) to set the minutes.
Press CLOCK again to confirm the time setting.
IMPORTANT!
– To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO POWER
2
on the set for
3 seconds or more to switch to normal standby mode first before proceeding with the procedures
below.
Setting the clock
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connected TV does not support progressive
signals or the cables are not connected accordingly, see the user manual for proper progressive
scan setup or deactivate the progressive scan feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM MENU on the remote to exit the system menu and then DISC to exit
progressive scan.
Tip
See chapters "Preparations" and "System
Menu Options" in the User Manual for
detailed descriptions.
DIVX(R) VODDIVX(R) VOD
CLOSED CAPTIONS
MCD288 QUG_Eng 2006.3.15, 16:033
 previous