Filter
Top Products
17
English
Getting Started
6 Press 1 2 repeatedly to select "VIDEO
SETUP PAGE".
7 Select "TV MODE" to "P-SCAN", then OK to
confirm.
➜ The instruction menu appears on the TV.
1. ENSURE TV HAS P-SCAN.
2. CONNECT YPRPB CABLE.
3. IF TV ABNORMAL:
WAIT 15 SEC RECOVERY.
8 Press 1 2 to highlight OK in the menu and
press OK to confirm.
There will be a distorted picture on your
TV at this state until you turn on the
progressive scan mode on your TV.
9 Turn on your TV progressive scan mode (refer
to your TV user manual).
➜ The below menu appears on the TV.
CONFIRM TO USE P-SCAN,
IF PICTURE IS GOOD,
PRESS OK BUTTON ON REMOTE.
TIME LAST 01 SECOND
0 Press 1 2 to highlight OK in the menu and
press OK to confirm.
➜ The setup is complete now and you can start
enjoy the high quality picture.
To deactivate Progressive manually
● When the distorted sign still appears on
the TV, it may be due to the connected TV
does not accept progressive signals, and
progressive is set by mistake. You must reset the
unit to interlace format.
1 Turn off your TV progressive scan mode or turn
on to interlaced mode (refer to your TV user
manual).
2 Press SYSTEM on the remote to exit the
system menu and then DISC to exit progressive
scan.
➜ The DVD blue background screen will appear
on the TV.
Note:
– During normal playback in the progressive scan
mode, pressing DISC button will exit the progressive
scan mode.
pg 001-037_MCD708_98-Eng 2005.10.20, 9:3317