Filter
Top Products
English
31
Radio Reception
Tuning to radio stations
1 Press STANDBY-ONB to switch on the last
selected source.
2 Press SOURCE (TUNER on the remote) to
select TUNER (FM) mode.
3 Press and hold ¡1/2™ on the system (or 2/3
on the remote control) until the frequency
indication starts to change, then release.
➜ The system automatically tunes to the next
strong radio station.
● To tune to a weak station, press ¡1/2™ on the
system (or 2/3 on the remote control) briefly
and repeatedly until an optimal reception is
found.
4 Repeat Step 3 if necessary until you find the
desired radio station.
Presetting radio stations
You can preset up to 20 stations regardless of
the reception.
Automatic programming
● Press PROGRAM on the remote control for
more than two seconds to activate
programming.
➜ All available stations are programmed.
Manual programming
1 Tune to your desired radio station (refer to
“Tuning to radio stations”).
2 Press PROGRAM on the remote.
➜ ”PROG” icon flashes.
Other Functions
3 Press PRESET+/- (or ¡ / ™ on the remote
control) to select the desired preset number.
➜ If “PROG” icon goes off before you select the
desired preset number, press PROGRAM on
the remote.
4 Press PROGRAM on the remote again to
store the radio station.
● Repeat steps 1-4 to store other radio stations.
Listening to preset radio stations
● In tuner mode, press PRESET+/- (or ¡ / ™ on
the remote control) to select the desired preset
number.
➜ The preset number, radio frequency, and
waveband are displayed.
Setting the clock
1 In Standby mode, press and hold CLOCK on
the remote control until the time flashes on the
display.
➜ ”CLOCK SET” is displayed briefly. Then, the
hour digits flash on the display screen.
2 Tur n VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
hours.
3 Press CLOCK to confirm.
➜ The minute digits flash on the display screen.
4 Tur n VOLUME -/+ clockwise or anticlockwise
or press VOL +/- on the remote to set the
minutes.
5 Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
pg 020-039_MCD710_98_Eng 2007.12.27, 16:2831