Filter
Top Products
20
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note:
EXT.1 can handle CVBS and RGB, EXT.2 CVBS, RGB and Y/C, EXT. 3 and EXT. 4 only CVBS.
It is preferred to connect peripherals with RGB output to
EXT.1 or 2 as RGB provides a better picture quality.
If your recorder is provided with the EasyLink function, it should be connected to
EXT.2 to benefit from the
EasyLink functionality.
Recorder (VCR-DVD+RW)
Connect the aerial cables 1, 2 and, to obtain the optimum
picture quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder’s test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation, p. 7.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
See Decoder, p. 10. You can also connect your decoder directly to
EXT. 1 or 2 with a eurocable.
Other equipment (satellite receiver, decoder, DVD, games, etc.)
& Connect the aerial cables 1, 2 and 3 as shown (only if your
peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of the
euroconnectors
EXT.1, 2, 3 or 4 to obtain a better picture quality.
é Look for the test signal of your peripheral in the same way as you
do for a recorder.
“ Make a selection in the Setup, Source menu, p. 10.
Side connections Camera or Camcorder
& Connect your camera or camcorder as shown.
é Connect to VIDEO 2 and AUDIO L 3 for mono equipment.
For stereo equipment also connect
AUDIO R 3.
S-VHS quality with an S-VHS camcorder is obtained by connecting
the S-VHS cables with the S-video input 1 and audio inputs 3.
Do not connect cable 1 and 2 at the same time.This may cause
picture distortion !
Headphone
& Insert the plug into the headphone socket L as shown.
é Press ¬ on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.The
headphone socket has a 3.5 mm jack.
In the Sound menu select
Headphone volume to adjust the
headphone volume.
AUDIO
VIDEO
S•VIDEO
1 2 3
2
EXT.EXT.
2
EXT.
CABLE
1
4
2
3
1/21/2
EXT.EXT.
1/2
EXT.
CABLE
1
2
3
5
4
Connect Peripheral Equipment
2229.1 gb 12-03-2003 09:55 Pagina 20