Filter
Top Products
POWER-ON DEFAULT
The remote powers on in TV mode.
TV VOLUME/MUTE PUNCH-THROUGH
T he TV Vo l u me / M ute punc h - t h rough feature lets you
c o nt r ol the Vo l u me and Mute func t ion of your TV in
a n y mo de pro g r a m med to be a VCR, DVD, Cable or SAT
de v i c e, without ne e d i n g to change to TV mo d e. This
f e a t u re is also available if AUX mo de is pro g r a m me d
to cont rol a second VCR, Cable or SAT de v ic e.
VCR PUNCH-THROUGH
Punch-through to VCR mode is only allowed in TV,
VCR and Cable modes. SAT/DBS and CD/Audio are
dedicated to their modes.
CODE SETUP
T h e Code Search button is used to setup the re mo t e.
You can either setup the re mote using the code fo r
your bra n d of pro duct, from the code tables, or you
can search through the library of codes until you
f i nd a code that works for your pro duc t .
NOTE: You can store any kind of code under any mode
( except TV). I.E. you can store a VCR code under the
CBL ke y, or a DVD code under the VCR ke y, etc. You can
store ANY kind of code under the AUX key. However,
you can only store TV codes under the TV ke y .
5
BATTERY INSTALLATION
1. On the back of the remote,
push down on the tab and
lift the cover off.
2. Match the batteries to the
+ and - marks inside the
battery case, then insert 2
AAA Alkaline batteries.
3. Press the battery cover
back into place.
BATTERY SAVER
Your remote automatically
times out if the buttons are
depressed more than 30
seconds. This will save your
batteries should your remote
get stuck in a place where the
buttons remain depressed
(e.g., between the sofa cushions).
CODE SAVER
Codes are stored in permanent memory while you
are changing batteries so you will not lose any
codes stored in the remote while you are changing
batteries. If you do not want to delete any stored
codes, see page 15.
Setup
4
Code Search
PM725.manual 5/27/08 9:23 AM Page 4