Filter
Top Products
46
06
07
08
09
06
07
08
09
1
3
06
07
08
09
PIP
213
546
879
0
TV
SWAP PIP CH
DN
UP
SOURCE FREEZE
SOUND
MUTE
SURF
A/CH
POWER
PICTURE
STATUS/
EXIT
POSITION
VCR
ACC
MENU/
SELECT
VOL
CH
TV/VCR
4
2
4
2
SETTING THE TV REMOTE TO WORK ACCESSORY DEVICES
VCR
Cable TV Converter
Satellite Receiver
NOTE: The remote’s
back light will blink
as the remote moves
through its product
code list. After the
remote identifies the
product code for your
accessory device and
you release the remote
buttons, the back light
will blink twice.
Remote Control • Working Accessory Devices
Y
our TV remote can be set to work
various accessory devices (VCRs,
cable converters, and satellite
receivers, for example) by what is
called the Search Method.
NOTE: The Search Method works
only with devices equipped with
Channel Display Indicators or that
capability. If the Direct Access code
number method (shown in the previ-
ous section) did not enable your TV
remote to work your accessory device,
then follow the easy steps listed below.
Please read the steps once before per-
forming them.
Turn on the desired device. Press
and hold down the VCR or ACC
(for an accessory device other than
a VCR) mode button on the TV
remote. Then press and hold down the
SURF button as you hold down the
desired mode (VCR or ACC) button.
NOTE: You must press and hold
down the desired mode (VCR or
ACC) button first and then press and
hold down the SURF button second.
While holding down the SURF
and the desired mode (VCR or
ACC) buttons at the same time,
point the remote toward the accesso-
ry device and continue holding the
buttons down.
Watch the Channel Indicator on
your accessory device. Channel num-
bers will scan up when the TV remote
has identified the correct code for
your accessory device. This may take
several minutes.
Release the mode (VCR or ACC)
and SURF buttons as soon as chan-
nel numbers start to scan up. The
scanning means that your TV remote
has found the code for your accessory
device.
BEGIN
SEARCH METHOD
SMART HELP
• Your TV remote may
locate the accessory device’s
code quickly or require several
minutes to do so.
• Don’t let the accessory device scan
up more than five channels when
the correct code is found—the
remote may pass up the right code
and have to repeat the search
cycle.
• If no channel change happens after
several minutes, repeat steps 1–4.
Then if a channel change still does
not occur, the remote will not
work the desired accessory device.