Filter
Top Products
10 Automatic Channel Setup
Although the TV/VCR may automatically memorize the channels
you receive when you turn it on for the first time, you may set up
channels again by following the steps below.
1
Press the MENU button.
2
Press the PLAY/▲ button or the STOP/▼ button to select
PRIM. SETUP, then press the F.FWD/B button.
PRIMARY SETUP
> SELECT LANGUAGE
AUTO PROGRAMMING
CH MEMORY REVIEW
VOLUME BAR [ON]
SET CLOCK
SELECT KL CHOOSE B
TO END PRESS EXIT
3
Press the PLAY/▲ button or the STOP/▼ button to select
AUTO PROGRAMMING, then press the F.FWD/B but-
ton. AUTO CH PROGRAMMING ... will appear on the screen.
The TV/VCR distinguishes between TV channels and cable chan-
nels automatically, and the TV/VCR will memorize its available
channels.
• Line Input mode will always be
stored in the TV/VCR’s memory as
channel 00. You cannot delete it.
• You can select channels not stored
in the memory by using the number
buttons on the remote control.
However, you can not select non-
memorized channels using the
CH(annel) m/n buttons.
Helpful Hints
4
Wait for a few minutes. When setup is complete, CHANNELS
ARE SET will appear on the screen. Then the programming of the
lowest channel number placed in the TV/VCR’s memory will
appear on the screen. Now, when you press the CH(annel) m/n
button, you will scan only through channels you receive.
4
Wait for the TV/VCR to set up
channels.
1
2-3
VOL
.
CH.
321
654
987
0
POWER
STATUS/EXIT
TRACKINGREC/OTR
SPEED
MEMORY
ALT. CH
PAUSE/STILL
MUTE
F.FWDREW
PLAY
STOP
SLEEP/WAKE UP
MENU
CLEAR
> PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION
REMINDER
BRIGHTNESS
PRESS B