Filter
Top Products
Hooking Up the TV/VCR (cont’d) 7
Rod Antenna
(supplied)
Hooking Up Your TV/VCR with the
Supplied Rod Antenna
To install the supplied rod antenna, push the
base stem of the antenna into the antenna
hole on the back of the TV/VCR. Connect
the antenna wire to the ANT(enna) Jack on
the back of the TV/VCR as shown. Extend
the antenna and adjust its length, direction,
and angle for the clearest picture.
C.
2
Connect the AC power cord to
the AC 120V jack on the back of
the TV/VCR. Plug the AC power
cord into an AC power outlet.
Use only the supplied AC power
cord.
3
Before you turn on the TV/VCR,
go to page nine.
• Before connecting an antenna or cable signal to the
ANT(enna) Jack, make sure the pin is not bent. If the
pin is bent, straighten it as illustrated, then connect
the antenna or cable signal to the ANT(enna) Jack.
Helpful Hint
Crooked Pin
Straight Pin
Bent pin
Plug
Cable