Filter
Top Products
Hookups (cont’d) 15
Connecting to a TV and a Stereo
(Stereo has Dolby Digital
TM
or MPEG2)
Back of TV
(example only)
COAXIAL DIGITAL
AUDIO IN
2
1
Stereo
(example only)
VIDEO IN
VIDEO IN
3
1
Connect the Player’s COAXIAL jack to the Stereo’s
COAXIAL DIGITAL AUDIO IN jack. Use a coaxial digital
audio cable (not supplied). See your electronics retailer for details
and availability.
2
Connect the supplied video cable to the Player’s yellow
VIDEO (VIDEO OUT) jack and to the TV’s
VIDEO IN jack. The supplied video cable has yellow markings.
3
Plug the power cords of the DVD Player, Stereo, and the TV
into an active power outlet. Press STANDBY-ON
yy
on the
front of the DVD Player to turn it on.
4
Turn on the Stereo and set it to the correct Audio In
channel or sound source. Refer to the Stereo owner’s manual for
details.
5
Turn on the TV. Set it to the correct Video In channel. See
your TV owner’s manual for details. Or, go to your lowest TV
channel (01 or 02) and change channels downward until you see the
DVD screen on the TV.
• Set DIGITAL OUTPUT and
LPCM OUTPUT accordingly.
Details are on page 40.
• Your Stereo must support
MPEG2 or Dolby Digital
TM
.
Check the Stereo’s manual.
• If you prefer or need to use the
S-VIDEO or Y Pb Pr jacks
instead, see pages 12-13.
Helpful Hints