Philips PL1IRR Universal Remote User Manual


 
1
PL1IRR Remote Control
User’s Guide
IMPORTANT INFORMATION
Warnings and Notices
Philips Selecon Limited Three-Year Warranty
Philips Selecon offers a three-year limited warranty of its products against defects in materials or workmanship
from the date of delivery. A copy of Philips Selecon three-year limited warranty containing specific terms and
conditions can be obtained from the Philips Selecon web site at www.seleconlight.com or by contacting your local
Philips Selecon office.
When using electrical equipment, basic safety precautions should always be followed including the following:
a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
b. Do not use outdoors.
c. Do not use near gas or electric heaters.
d. The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
e. Do not use this equipment for other than intended use.
f. Refer service to qualified personnel.
SAVE THESE INSTRUCTIONS.
WARNING: You must have access to a main circuit breaker or other power disconnect device
before installing any wiring. Be sure that power is disconnected by removing fuses or turning the
main circuit breaker off before installation. Installing the device with power on may expose you to
dangerous voltages and damage the device. A qualified electrician must perform this installation.
WARNING: Refer to National Electrical Code® and local codes for proper use specifications.
WARNING: This equipment is intended for use in accordance with the National Electric Code® and
local regulations. It is also intended for installation in indoor applications only. Before any electrical
work is performed, disconnect power at the circuit breaker or remove the fuse to avoid shock or
damage to the control. It is recommended that a qualified electrician perform this installation.
WARNING: The PL1IRR Remote Control contains a Class 2 laser. Do not look directly into laser
beam or damage to eye may result. Handle with caution.
LASERRADIATION
DONOTSTAREINTOBEAM
CLASS2LASERPRODUCT
LASERDIODE
WAVELENGTH: 630-680nm
MAXOUTPUT: <5mW