Philips PRI85SUBCV CRT Television User Manual


 
3
Remote control keys
& Standby
To set the TV to standby mode. To switch the TV
set on again,press b,P @#or 09.
é Sleeptimer
To select the length of time before the set
automatically switches to standby (from 0 to 240
minutes).
Select peripherals (p.10)
Press several times to select the required EXT
connector.
Teletext keys (p.8)
( Dual screen
(according to the version)
To activate/disable the display on 2 screens. The
second screen displays teletext.
§ Menu
To call up or exit the menus.
è Cursor / Format
These 4 keys are used to navigate through the
menus.(p.9)
! Volume
To adjust the sound level.
ç Mute
To mute or restore the sound.
0 Screen information
To display / remove the programme number,the
name (if it exists),the time,the sound mode and
the time remaining on the timer.Hold down for 5
seconds to permanently display the programme
number on the screen.
1 Sound mode
Used to force programmes in Stereo and Nicam
Stereo
to Mono or,for bilingual programmes,to
choose between Dual I or Dual II.
The Mono indication is red when in forced position.
2 Surround Sound
To activate / deactivate the surround sound effect.In
stereo,this gives the impression that the speakers are
further apart. For models equipped with Virtual Dolby
Surround*,you can experience Dolby Surround Pro
Logic sound effects.
3 Smart picture and sound
Used to access a series of predefined
picture and sound
settings.
The personal position relates to settings selected from the
menus.
4 Teletext call (p.8)
5 Programme selection
To access the next or previous TV channel from the
list of Favourite Programmes (see p.5).
6 Digit keys
Direct access to the programmes.For a 2 digit
programme,enter the 2nd digit before the dash
disappears.
7 Active Control
(according to the version)
Optimizes the quality of the picture according to the
quality of reception.
Plug the TV into a 220V – 240V AC, 50 Hz supply.
Disconnect mains plug when :
– the red light below the TV screen is flashing continuously.
– a bright white line is displayed across the screen.
– there is a lightning storm.
– the set is left unattended for a prolonged period of time.
Cleaning the TV screen.Never use abrasive cleaning agents.Use a slight damp chamois leather or soft cloth.
No naked flame sources, such as lighted candles,should be placed on top of the TV or in the vicinity.
Do not place your TV set under direct sunlight or heat.
Do not cover or block the TV as it could lead to overheating.
Leave at least 5 cm around each side of TV set to allow for proper ventilation.
Avoid placing your set (e.g. near the window) where it is likely to be exposed to rain or water.
Battery Usage CAUTION – To prevent battery leakage that may result in bodily injury, property damage, or damage
to the unit:
Install all batteries correctly, with + and – aligned as marked on the unit.
Do not mix batteries (old and new or carbon and alkaline, etc.).
Remove batteries when the unit is not used for a long time.
Useful Tips
Do not leave your set on standby mode for a prolonged
period of time. Switch off set to allow it to be demagnetised. A demagnetised set supports good picture quality.
Do not shift or move the set around when it is switched on.Uneveness in colour in some parts of the screen may
occur.
Never attempt to repair a defective TV yourself. Always consult a skilled service personnel.
Safety Information
Esp Zappa 1333.3 GB only 1/9/06 2:52 PM Page 3