Filter
Top Products
8
TROUBLESHOOTING
Red Indicator Light does not
blink when you press a key.
Replace the batteries with two
(2) "AA" alkaline batteries (see
Page 4).
The VOL+,VOL- and MUTE
keys are not functional.
Make sure that the volume con-
trol is locked to a component
that has volume capabilities and is
programmed into the remote
control.
Red Indicator Light blinks when
you press a key,but home enter-
tainment component does not
respond.
Make sure you are aiming the
remote control at your home
entertainment component and
that you are within 15 feet of the
component you are trying to
control.
The remote control does not
control home entertainment
components or commands are
not working properly.
Try all listed codes for the com-
ponent brand being set up. Make
sure all components can be oper-
ated with an infrared remote
control.
CH+,CH- and LAST do not
work for your RCA TV.
Due to an RCA design (1983-
1987),only the original remote
control will operate these func-
tions.
Changing channels does not
work properly.
If original remote control
required pressing ENTER to
change channels,to change chan-
nels,press ENTER on the
remote after entering a channel
number.
Tried Auto Scan and still could
not find a working code.
Try Auto Scan again after clearing
out the component key as fol-
lows: Press and hold SET until
Red Light blinks twice,then
release. Next enter 9-9-2. Then
press and release the component
key to be cleared twice.
NOTE: To clear all set up codes and restore functions to Default,
press SET until red light blinks twice,release SET and enter 9-8-1.
Caution:When this clear feature is performed, please note that all of
your set up codes will be reset to the default codes and you will need
to reprogram components.
PROBLEM: SOLUTION:
7
Press component*
key once (e.g., CBL).
Press SET
until Red Light
blinks twice;
release SET.
Press VOL+ once.
Volume now controlled
through component
selected in step 1.
x 2
123
* NOTE: Component must have
volume capabilities.
Volume Lock
QUICK FEATURES SETUP GUIDE
This guide is provided here for your convenience as a quick refer-
ence for performing remote control sequences.
Turn on
component
(e.g., TV).
Press component
key once
(e.g., TV).
Press SET
until Red Light
blinks twice;
release SET.
Aim remote at
component; press
SCAN once. When
off, press any
key* to stop.
x 2
Press SET
until Red Light
blinks twice;
release SET
to lock code.
x 2
12 3 4 5
* NOTE: Not VOL-, SCAN, or SET.
Auto Scan
Press component
key once
(e.g., TV).
Press SET
until Red Light
blinks twice;
release SET.
Enter 9-9-0;
the Red Light
will blink twice.
Press 1 once for 1st digit.
Wait 3 sec. and count blinks.
Number of blinks equals
value of code digit.
Repeat with 2, 3, and 4.
x 2
x 2
12 3 4
Code Verification
Turn on
component
(e.g., TV).
Press component
key once
(e.g., TV).
Press SET
until Red Light
blinks twice;
release SET.
Enter 4-digit code
for your brand;
Red Light blinks
twice after last #.
Press POWER
once; if no
response,
repeat steps
with next code.
x 2
x 2
#
# # #
12 3 4 5
Component Setup