Filter
Top Products
VCR
Rewind
Record
Play
Stop
Forward
Pause
SET-UP FOR USE
A DVICE
Carefully read the complete procedure before starting!
Your equipment is a Philips brand:
1 Press the mode key for the device (TV, VCR or SAT) you
want to operate.
2 Press the power key to test.
– The green indicator LED lights up to confirm transmission
C HECK
Press a few keys to check correct response. If response is not
correct go to the next paragraph
Your equipment is of another brand or your
equipment is a Philips brand, but not all keys
respond correctly:
1 Look up the brand name of the equipment you want to
operate in the code list (centre of this manual).
2 Make sure the equipment is switched on.
3 Press the mode key and select the device (TV, VCR or
SAT) you want to operate.
4 Press and hold keys mute and power simultaneously - for
about three seconds- until the green LED lights up.
(Release the keys: the green LED should stay on)
5 Enter your 6-digit code within 30 seconds.
(PROG– = 0, PROG+ = 1, VOL– = 2, VOL+ = 3) e.g. when
the code is 012313 press PROG–, PROG+, VOL–, VOL+,
PROG+, VOL+.
– The green LED flashes twice.
C HECK
That’s it! Press a few keys to check correct response.
If response is not correct, repeat procedure beginning
at step 1 using the next 6-digit code in the list.
N
OTE
- If the LED displays one long flash, the code was not
recognised. Please go back to step 1 and repeat the
procedure, using the next 6-digit code in the list.
- If no key is pressed within 30 seconds, you have to start
again at step 1.
- If no correct code is in the list, go to the next paragraph.
Instructions for use
3
English
+
PROG
-
PROG
-
VOL
+
VOL
MODE
MODE
XP SBC RU 130 16-06-2000 10:19 Pagina 3