Filter
Top Products
RU240- page 4
4
Make sure the TV, VCR etc. is switched on. If it’s a VCR, insert a tape
and start playback. You will know when the correct code has been found
because the equipment will switch off or the VCR will stop playback.
1 Press and hold and at the same time - for about 3
seconds - until the green LED lights up. (Release the keys, the
green LED should stay on)
2 Press to start the search. Each time the green LED blinks,
another code is sent. When the right code is found, the equipment
switches off (the VCR will stop playing).
3 Immediately press to stop the search.
If you missed the correct code because the search went too far, switch
the equipment back on, then press to send the previous code
again. Keep pressing down repeatedly until the equipment
switches off again.
4 Once you’ve found the correct code, press to lock the code in the
memory. The green LED will blink twice.
That’s it! Now, switch the equipment on again manually, then press a
few keys on the remote to check that the equipment responds
correctly. In the rare instance that it doesn’t, try again from step 1 to
find a better code.
In case none of the codes work or if you are still missing certain
functions of your original remote control, try the solution we offer you
in the section ‘Copy (learn) codes from your original remote control’ or
call our free-phone helpline, they can help you out with any query you
might have.
Note that code! To save time if you ever need to setup again, make a
note of the correct code inside the battery case and in the back of this
booklet. In case you have forgotten to note the code you can still
‘read out’ the code from the remote. Here’s how:
1 Make sure you’ve selected the right mode (with ).
Then press and hold and at the same time -for about 3
seconds- until the green LED lights up. (Release the keys, the green
LED should stay on)
2 Press . The green LED goes out.
3 Press and count the number of times the green LED blinks. This
is the first digit of the 3-digit code. (No blinks means the digit is
zero.)
Press and count the number of blinks for the second digit.
Press and count the number of blinks for the third digit.
COPY (LEARN) CODES FROM YOUR ORIGINAL REMOTE CONTROL
If your equipment is not included in the codelist, or if specific
codes on your remote control are missing, the RU460 has the solution.
It can copy and replicate up to 100 codes from your original remote
controls. Here’s how...
Before you start, make sure you’re in the mode you’re setting up (TV,
VCR, SAT/CBL, CD, AUDIO1, AUDIO2). The green indicator LED shows
which mode is selected. To switch between modes, press once
to activate, then press it again to advance to the next mode.
3
3
2
2
1
1
6
6
1
1
P
P
P
P
3
3
1
1
English