Filter
Top Products
Automatically setting the remote control
If you cannot find the right code for your brand device,
the remote control can automatically search for the right code.
Example of TV:
1 Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU538 emits the ‘switch off TV’ signal for all models of TV that are
stored in the memory.
• If the device is a DVD-player or video recorder,
insert a disk or tape and start playback.
2 Then keep keys 1 and 3 on the RU538
pressed simultaneously for three seconds,
until the green light under TV in the selector
window flashes twice and then remains lit.
3 Press the Standby key of the RU538 briefly.
– The RU538 now starts emitting all known
‘TV off ’ signals, one by one.
Each time a code is sent, the green light under
TV in the selector window lights up.
4 When your TV switches off (stand-by),
you press the Standby key of the RU538
twice within 1 second, to confirm.
– The RU538 has now found a code that works
on your TV.
5 Check if you can operate all functions on your TV with the RU538.
• If this is not the case, you can redo the automatic setting.
The RU538 will then search for a code that perhaps works
better.
– After the RU538 has run through all the known codes,
the search will stop automatically and the green light will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
For VCR and DVD this time is 2 minutes.
TV VCR DVD
TITLE DISC
....
TV VCR DVD
TITLE DISC
....
TV VCR DVD
TITLE DISC
....
M
E
N
U
O
K
SHIFT
123
456
78
0
9
7
Instructions for use
English
2x
XP SBC RU 538/87.2 10-02-2004 09:54 Pagina 7