Filter
Top Products
3
RU240- page 3
If you know the brand of your equipment, look at the code list at the
back of this booklet, and find the first 5-digit code for your equipment.
1 Press and hold s and y at the same time until the green LED lights
up. (Release the keys, the green LED should stay on)
2 Enter the 5-digit code using the numbers that correspond to the
function keys (see diagram). The green LED blinks twice.
That's it! Now, press a few keys on the remote to check that the
equipment responds correctly. If it doesn't, try again using the next code
in the list. In the rare instance that none of the codes work, follow the
instructions in the next section.
Tip: Make a note of the code inside the battery case, and in the back of
this booklet in case you ever need to setup again.
If you don't know the brand of your equipment or if you can not find
it in the codelist, setup still won't take long. Philips' patented Handsfree
autosearch tests all the codes one after another and finds the right one
for you! The search time averages about 90 seconds. (Maximum search
time is 5 minutes for TV.)
Make sure the TV is switched on. You will know when the correct code
has been found because the equipment will switch off.
1 Press and hold s and y at the same time until the green LED lights
up.
2 Press y to start the search. Each time the green LED blinks, another
code is sent. When the right code is found, the equipment switches
off.
3 Immediately press y to stop the search.
If you missed the correct code because the search went too far, switch
the equipment back on, the press -P (down) to send the previous code
again. Press -P (down) repeatedly until the equipment switches off
again.
4 Once you've found the correct code, press y to lock it in memory.
The green LED blinks twice.
That's it! Now, switch the equipment manually on again, then press a
few keys on the remote to check that the equipment responds correctly.
In the rare instance that it doesn't, try again from step 1 to find a better
code.
Note that code! To save time if you ever need to setup again, make a
note of the correct code inside the battery case and in the back of this
booklet. In case you have forgotten to note the code you can still 'read
out' the code from the remote. Here's how:
1 Press and release s and y at the same time; the green LED lights
up.
2 Press
s . The green LED goes out.
3 Press
+P and count the number of times the green LED blinks. This
is the first digit of the 5-digit code. (No blinks means the digit is
zero.)
Press -P and count the number of blinks for the second digit.
English