Philips SDV7225T/27 TV Antenna User Manual


  Open as PDF
of 12
 
8
Mount on the wall
Mount two wood screws onto the wall.
Ensure the distance between two screws is
80mm (3.149”).
Set up a digital tuner with this
antenna
You can install available channels with the digital
TV tuner. This automatic process is part of the
setup of the tuner. Ensure the antenna has
set up properly before the tuner can receive
viewable channels.
There are two ways to connect the antenna to
the TV:
Connect the antenna to a digital tuner. •
If the signal strength is good enough, the
channels can be memorized in the tuner
automatically .
Connect the antenna directly to the TV. •
Tunetotheanaloguechannelsandnd
the best antenna location. Then re-
connect the antenna to the digital tuner.
Ensure the signal strength is good enough
before you install the channels with the
tuner.
3 TurnontheamplierbyrotatingtheVHF/
UHF gain control knob towards the max
position until better reception is achieved.
Tip
For best reception, turn the gain control down •
to a lower setting.
For UHF reception
1
Turn the TV to the desired channel/
station.
2 Toturntheamplierup,rotatethegain
control knob towards the max position.
Note
It is possible to turn the gain control knob •
down for best reception.
EN
 previous next