Filter
Top Products
TV2
Getting started
Note: If the VCR or DVD recorder
records a television program, you watch
the recorded channel.
3.4
Install the remote control
blaster cord
The remote control blaster cord
transmits IR signal to Source devices.
1 Switch off the transmitter (A).
Note: how to watch a video source on
TV1?
Use your TV1 and your video source as
usual to watch a video source on TV1.
2 Connect the remote control blaster
cord (D) to the IR socket.
3 Position the blaster light in front of
the video source. Just put it in front
of the IR sensor on the front panel.
Note: See the user manual of the video
source for the exact location of the IR
sensor on the front panel.
3 Find the CHANNEL switch on the
receiver (B).
4 Set the CHANNEL switch to the
same number as on the
transmitter (A).
3.5 Remove interference on TV2
1 Find the CHANNEL switch on the
transmitter (A). T
2 Set the CHANNEL switch to a
different number
on the
transmitter (A) in case of
interferences.
here are 4 channels.
You may have to change the channels
in case of interferences.
When 3.1 and 3.2 are done, you may
have some interferences.
4 Switch on the transmitter (A).
5 If the IR control blaster is well
installed, you can use your remote
control to manage your video source.
11
English
11
EN