Filter
Top Products
5
3 Installing your wall mount
In this chapter, the basic steps to get you started
are described.
B Warning
Carefully read the safety precautions
in “Section 1 Important” before you
install the wall mount.
3.1 Mounting the wall plate (drywall)
B Warning
For safety reasons, this LCD mount
must be secured to a wood stud. The
stud must be capable of supporting
the combined weight of the mount
and display.
1
See enclosed mounting template for
diagram and guide of how to mount
properly on the wall.
2
Using a stud finder, locate and mark the
stud for securing the mount (make sure
your mark is in the center of the stud).
You can use your own stud finder or the
one included in the hardware kit.
Note: Once stud has been located you will
need to verify with a hammer and a nail
A) Simply place the nail over your mark on
the wall and tap in with hammer. If the
nail encounters resistance and is secure
in wall you have verified a stud location.
B) If it just pushes through with no
resistance you will need to start over
and locate the stud.
3
Using the enclosed mounting template,
place the diagram against the wall and mark
two locations (top and bottom) on the wall
where the mount is to be installed. Be sure
to use the center of the stud.
4
With the help of another person, place the
mount against the wall and level it using the
bubble guide.
5
While another person holds the mount
in place, mark two locations (top and
bottom) on the wall where the mount is
to be installed. Be sure to use the center of
the stud. (these marks should line up with
the ones made in step 3 above using the
template).
6 Set the mount aside and drill a 1/8” (3mm)
pilot hole at each marked location.
7 Place the mount back against the wall
and secure it using the wood screws (A)
provided. Do not over-tighten these screws
and do not release the mount until all
screws are in place.
8 Once both wood screws are in place you
must tighten each one. Be sure not to over
tighten.
1
1
3.2 Mounting the wall plate
(concrete/brick installation)
B Warning
For safety reasons, the concrete wall
must be capable of supporting the
combined weight of the mount and
display.
1
See enclosed mounting template for
diagram and guide of how to mount
properly on the wall.
2
Using the enclosed mounting template,
place the diagram against the wall and mark
two locations on the wall where the mount
is to be Installed.
3
With the help of another person, place the
mount against the wall and level it using the
bubble guide.
4
While another person holds the mount
in place, mark two locations on the wall
where the mount is to be installed.