Philips SQM5562/27 TV Mount User Manual


  Open as PDF
of 24
 
6
2 Using the enclosed mounting template,
placethediagramagainstthewallandmark
four locations on the wall where the mount
is to be Installed.
3 With the help of another person, place the
mount against the wall and level it using the
bubble guide.
4 While another person holds the mount
inplace,markfourlocationsonthewall
where the mount is to be installed.
5 Set the mount aside and drill a 3/8” (10
mm)pilotholeateachmarkedlocation.
Remove any excess dust from the holes.
6 Insert a Concrete Anchor (P) into each
holesothatitisushwiththeconcrete
surface. A hammer can be used to lightly
tap the anchors into place if necessary.
7  Placethemountbackagainstthewalland
secure it using the lag bolts (Q) and lag bolt
washers (R) provided. Do not over-tighten
these bolts and do not release the mount
until all bolts are in place.
8 Once all (4) lag bolts are in place you must
tighten each one. Be sure not to over
tighten. 2
2
D Note
If the concrete wall is covered
by a layer of plaster or drywall,
the concrete anchor must pass
completely through the layer to rest
ush with the concrete surface.
3.3 Attaching the arms to the display
B Warning
Use extra care during this part of the
installation. If possible, avoid placing
your display facedown as it may
damage the viewing surface.
D Note
Your mount comes with a selection
of bolt diameters and lengths
to accommodate a wide variety
of display models. Not all of the
hardware in the kit will be used.
1
Determine the correct length of bolt to
usewithyourdisplaybyrstexaminingthe
backofyourdisplay.
A. If your display has a flat back:
You will
use one of the shorter bolts (A, D, G, or J)
fromthehardwarekit.
3
3
B. If your display has a curved or
recessed back:
You will use one of the
longer bolts (B, E, H, or K) along with a
spacer (M or N).
4
4
 previous next