Filter
Top Products
4 EN
English
5EN
Getting started
5 Switch ON the TV.
Try out the buttons
you need for
operating it. Try, for
example, if the
- CH + and digit
buttons function properly.
• If a button does not work as expected, press
and hold that button. Release it immediately
as soon as it works. For more information,
see chapter 2.2.2.
6 Press the
device selection
button twice to
finish setup.
• When no
button is
pressed for 5 minutes or more, the
remote control will exit setup mode,
automatically saving all your settings.
Important
If you made a mistake:
• Press the device selection button twice to
exit setup.
The red Setup light turns off.
•
Restart from the beginning.
• If the device does not respond at all or not to
all of the button commands or if you cannot
find the code for your brand, enter ‘9, 9, 9, 9’ in
step 3 and continue with step 4. The remote
control will now search its full database for a
code that works with your TV. Full database
search may take up to 15 minutes.
2.2.1 Setting up the remote control for
other devices (
DVD player / recorder
and Cable / Satellite box
)
1 Make sure the device is switched on and
operational. E.g. insert a disc in the DVD
player / recorder.
2 Then follow steps 2 to 6 of ‘Setting up the
universal remote control to operate your
TV’. Make sure to use the correct device
selection button: or .
CBL/SAT Cable box, satellite
receiver, Internet Protocol
TV (IPTV), Free To Air TV,
High Denition Television
decoder (HDTV) and TiVo
Example: setting up the universal remote
control to operate your TV:
1 Switch ON the TV manually or use the
original remote control for this. Tune to
channel 1.
2 Press and hold the
deviceselection
button for 5 seconds
until the red Setup
light blinks.
• The remote
control is now in setup mode.
3 Look up the 4-digit
code for your brand
in the
brand list
at
the back of this user
manual.
A 4-digit code is
shown for each brand.
Use the digit
buttons to enter the
code for your brand.
• If the red Setup
light turns off,
an invalid code
was entered. In this case, try again.
4 Aim the remote
control at the TV.
Press and hold the
button.
Release it
immediately as soon
as the TV switches off.
• This step normally takes between 5 and
60 seconds. In extreme circumstances
this step can take up to 15 minutes.
5 sec.
5 - 60 sec.
5-60 SEC
.
2 x