Filter
Top Products
Instructions for use
English
5
Setting the remote control
This is only necessary if your TV does not respond to the SRU 5010.
If that is the case, the SRU 5010 does not recognize the brand and/or model
of your TV and you need to program the remote control to do so.
You can set the remote control either automatically or manually.
Automatically setting the remote control
The remote control will now automatically search for the right code for your
device.
1 Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The SRU 5010 emits the ‘switch off TV’ signal for all models of TV that
are stored in the memory.
2 Then keep keys 1 and 3 on the SRU 5010
pressed simultaneously for three seconds,
until the LED flashes twice and then remains lit.
3 Press and hold the Standby key
of the SRU 5010.
– The SRU 5010 now starts emitting all known
‘TV off’signals, one by one.
Each time a code is sent, the LED
lights up
4 When your TV switches off (stand-by), release
the Standby key of the SRU 5010 immediately.
– The SRU 5010 has now found a code that works on your TV.
5 Check if you can operate all functions on your TV with the SRU 5010.
• If this is not the case, you can redo the automatic setting.
The SRU 5010 will then search for a code that works better.
– After the SRU 5010 has run through all the known codes,
the search will stop automatically and the LED will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.