Filter
Top Products
VCR/TVPOWER EJECT
1 2 3
4 5 6
7 8 9
0 +100
CHANNEL
INDEX
SLOW
SPEED
QUICK-
FIND
TIME
EXIT COUNTERDISPLAY
MENU
RESET MEMORY
REWIND / PLAY F.FWD
RECORD PAUSE/STILL
/ STOP
SEARCH
Turning on Your VCR 11
● Before turning on your VCR, make sure there are batteries in
the remote control and the VCR and TV are connected (see
pages five - 10).
● You can not set up channels if you are using a Cable Box/DBS.
● The instructions on this page only work when you turn on the
VCR for the first time. If there is a power failure or if the VCR
is unplugged for more than one minute, you may need to repeat
the instructions on this page.
1
Press the POWER button. The POWER light and the VCR/TV
light will appear.
2
Turn on the TV. Set it to the same channel as the
CH3/CH4 switch on the back of the VCR. The menu shown
below will appear.
2
1
Turn on the TV.
• If you do not see any on-screen dis-
plays when you turn on the VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps under
“Automatic Channel Setup” on page
12 and “Language Selection” on
page 16.
Helpful Hints
LANGUAGE SELECT
→ ENGLISH [ON]
ESPAÑOL
5
Press the MENU button, the F.FWD button, or the
REWIND button to begin automatic channel setup.
TUNER SET UP will flash on-screen. The VCR will memorize all
available channels, so when you use the CHANNEL o/p buttons,
you’ll only scan through channels that you receive. When channels
are set up, the TV will go to the lowest channel available.
(If you try to set up channels when there is no antenna or cable
connected to the VCR, programming will appear to take place.
Eventually, TUNER SET UP will appear on-screen steadily, and
channel programming will stop. Connect an antenna or cable to
the VCR, then press the MENU button, the F.FWD button, or the
REWIND button again. Channel programming will begin again.)
3
Press the PLAY button or the STOP button to select
ENGLISH or ESPAÑOL. [ON] will appear beside your choice.
4
Press the F.FWD button or the MENU button. TUNER SET
UP will appear on-screen.
TUNER SET UP
5
3
4
SVZ142.comb 4/7/99 6:30 PM Page 11