Philips TU-CT20 TV Converter Box User Manual


 
Welcome
We hope you have many years of enjoyment from your new Panasonic Digital
converter box.
The simple, easy to follow instructions will enable you to quickly set up and install
the equipment and begin your enjoyment of the available services.
The availability of Digital services in your area is dependent on the transmissions
received by your aerial and the configuration of your existing equipment.
Warnings and precautions
This Digital converter box (DCB) is intended for the reception of Digital TV
picture and sound signals.
If the Digital converter box (DCB) is exposed to drastic temperature changes,
e.g. taking it from a cold room to a warm room, connect it to the mains supply
and let it stand for at least two hours.
Do not expose the Digital converter box (DCB) to any moisture. The Digital
converter box (DCB) is designed for use indoors and should be protected
against moisture (splashes of water etc.).
Do not expose the Digital converter box (DCB) to dripping or splashing water
and objects filled with liquid, such as vases, must not be placed on top of or
above the unit.
Adequate ventilation is essential to prevent failure of electrical components, we
recommend that a gap of at least 5cm is left all around this Digital converter
box (DCB) even when it is placed inside a cabinet or between shelves.
Ensure that the ventilation holes beneath the unit are not blocked.
Do not place the receiver in the immediate vicinity of a heat source or in direct
sunlight as this would prevent appropriate cooling.
To prevent fire, never place any type of candle or naked flame on top of or near
the Digital converter box (DCB).
Caring for your Digital converter box (DCB)
Remove the mains plug from the wall socket. The cabinet can be cleaned with
a dry clean cloth. Do not use solutions containing benzol or petroleum.
Make sure that all the electrical connections are properly made. Do not connect
any of your equipment (TV, video recorder, etc.) to the mains supply until you
have properly connected all the other leads. Disconnect your Digital converter
box (DCB) from the mains supply before you disconnect any other equipment
from its rear panel.
2