Filter
Top Products
Mobile Connections (VPZ215AT only) 11
When passengers in your vehicle want to watch a video program, hook up the VCP by following the steps
below.
1
Make sure your vehicle has a
12-volt, negative ground elec-
trical system and the AC
power cords of the VCP and
the TV are unplugged.
2
Connect one end of the car
battery cord to the DC 13.2V
Jack on the back of the VCP.
3
Connect the other end of the
car battery cord to the ciga-
rette lighter jack in your vehi-
cle.
4
Follow step 3 on page seven
to connect the VCP to a TV.
CH3
CH4
ANT OUT
ANT IN
AUDIO
OUTPUT
VIDEO
DC13.2V
Back of VCP
AC Power Cord
Car Battery Cord
(supplied)
To DC 13.2V Jack
To Cigarette Lighter Jack
• Do not watch TV while driving.
• Use only the supplied car battery cord. Using another cord could damage the VCP or cause faulty operation.
• Make sure the cigarette lighter jack is free of ashes and other debris.
• Make sure you push the car battery cord’s plug completely into the cigarette lighter jack.
• Always unplug the car battery cord from the cigarette lighter jack before you unplug it from the VCP.
• You must disconnect the car battery cord from the VCP before you can use standard AC electrical power.
• If the vehicle’s engine is off, there will not be enough electrical voltage to operate the VCP.
• Unplug the car battery cord from the cigarette lighter jack when you have finished using the VCP.
• You may connect your VCP’s AUDIO/VIDEO OUTPUT jacks to the Audio and Video input jacks on your TV.
Details are on page 10.
Helpful Hints
5
Connect the TV to a DC
power source. The TV must
have an AC/DC Jack.
VPZ210/VPZ215 4/3/99 3:16 PM Page 11