Filter
Top Products
10 Hookups With a Stereo TV
R
L
VIDEO
IN
OUT
IN
OUT
AUDIO
CH3
CH4
OUT
IN
ANT
1
Connect the antenna or cable to the ANT(enna) IN Jack on the back of the
VCR.
2
Connect a video cable (not supplied) to the yellow VIDEO OUT Jack on the
back of the VCR. Then, connect the other end of the video cable to the
VIDEO IN Jack on your TV.
4
Turn on your TV, making sure it is in Line Input mode. Please refer to your TV
owner’s manual for details.
Video Cable
Audio Cable
VIDEO
IN
OUT
CH3
CH4
AUDIO
OUT
IN
ANT
antenna or cable
antenna or cable
Video Cable
Audio Cable
3VRZ220
Connect an audio cable (not supplied) to the white AUDIO OUT Jack on
the back of the VCR. Then, connect the other end of the audio cable to the
AUDIO IN Jack on your TV.
If your TV has Right and Left AUDIO IN Jacks, you must use a “Y” splitter audio cable
as illustrated to deliver audio to the TV’s right and left channels. This hookup will not
give you stereo sound. To get stereo sound, use the connections on pages six-seven
and select the channel to be viewed at the TV (with the VCR turned off).
3VRZ250
Connect an audio cable (not supplied) to the red and white AUDIO OUT
Jacks on the back of the VCR. Then, connect the other end of the audio
cable to the AUDIO IN Jacks on your TV.
VRZ220
VRZ250
VRZ220/250 layout 4/8/99 10:11 PM Page 10