Filter
Top Products
Timer Recording With the VCR Plus+ Programming System 35
• If you enter an incorrect PlusCode
programming number at step 4,
ERROR-RE-ENTER CODE will flash
on-screen. Enter the correct
PlusCode programming number.
Helpful Hint
Follow the steps below to program a timer recording using
PlusCode programming numbers. Before you begin make sure:
• Channels are set up. Details are on pages 11 - 12.
• The clock is set. Details are on pages 13 - 17.
• There is a tape in the VCR. Make sure the tape’s record tab is
intact and the tape is long enough to record the program(s).
• The VCR is in VCR position (the VCR light will appear on the
display panel). If the VCR light does not appear, press the
VCR/TV button once.
• You have programmed the VCR Plus+ and Cable/TV channel
numbers. Details are on pages 33 - 34.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may start again at step 1.
1
Press the VCR button.
2
Press the TIMER button.
4
Use the Number buttons to enter the PlusCode program-
ming number of the program you wish to record. (This
number is different for every program, and it can be four to eight
digits long.)
3
Press the PLAY 8 or STOP 9 button to select VCR
PLUS+, then press the FF :/OK button.
VCR PLUS+ PROG. CODE
VCR PLUS+ L
TO END PUSH EXIT
VCR PLUS+ PROG. CODE
VCR PLUS+ 1234L
TO SET PUSH :/OK
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
SELECT ,9 CHOOSE :/OK
A VCR PLUS+
QUICK PROGRAMMING
PROGRAM REVIEW
TO END PUSH EXIT
–
+
J
........
–
+
........
1
4
7
SPEED
CBL/DBS TV VCR
MENU
EXIT/STATUS
TIMER
SKIP
JOG/SHTL
STILL/SLOW
–
STOP L
PLAY :
+
3 FWD REV 2
c
c
EJECT
POWER
2
5
8
0
QUICK PROGRAMMING
3
6
9
START
DBS
STOP
DAILY
DATE
WEEKLY
CLEAR
CHVOL
REW FF
/OK
VCR/TV
7;; INDEX ::7
AUDIO/MUTE
::;;
REC /OTR
2
1
3
4
Instructions continue on page 36.
VRZ364/VRZ344 4/7/99 8:10 PM Page 35