Filter
Top Products
Connections
02
12
En
Watching progressive scan video
from the component video outputs
This player can output progressive scan video
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see
Video Output settings
on page 32.
When the player is set to output progressive
scan video, the
PRGSVE
indicator lights in the
front panel display.
Important
• When
Component Out
(page 32) is set to
Progressive
, there is no video output from
the
VIDEO OUT
(composite) jack.
• If you want to display video on more than
one monitor simultaneously, make sure
the player is set to
Interlace
.
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the player to progressive, you will not be
able to see any picture at all. In this case,
switch everything off and reconnect using
the supplied video cable (see
Easy
connections
on page 10), then switch back
to
Interlace
(see below).
Switching the video output to interlace
using the front panel controls
Switch the player to standby then, using the
front panel controls, press
STANDBY/ON
while pressing
to switch the player back
to
Interlace
.
Connecting to an AV receiver
To enjoy multichannel surround sound you
need to connect this player to an AV receiver
using the digital audio output.
In addition to a digital connection, we
recommend also connecting using the stereo
analog connection.
You’ll probably also want to connect a video
output to your AV receiver. You can use any of
the video outputs available on this player (the
illustration shows a standard (composite)
connection).
1 Connect the DIGITAL AUDIO OUT
COAXIAL jack on this player to a coaxial
digital input on your AV receiver.
Use a coaxial cable (similar to the supplied
video cable) to connect the
DIGITAL AUDIO
OUT COAXIAL
jack to a coaxial input on your
AV receiver.
2 Connect the analog AUDIO OUT L/R
and VIDEO OUT jacks on this player to a set
of analog audio/video inputs on your AV
receiver.
You can use the SCART AV connector, or the
component video jacks to connect to the AV
receiver if you prefer.
STANDBY/
ON
STANDBY/ON
DIGITAL AUDIO OUT
L
R
P
R
PB
Y
COAXIAL
COMPONENT VIDEO OUT
AUDIO OUT
VIDEO OUT
AV receiver
To coaxial digital
input
DIGITAL AUDIO OUT
L
R
P
R
PB
Y
COAXIAL
COMPONENT VIDEO OUT
AUDIO OUT
VIDEO OUT
AV receiver
To audio/video inputs
DV300_WY_EN.book 12 ページ ２００７年１月２５日 木曜日 午後７時２３分