Filter
Top Products
7
English
En
ABOUT REGION CODES
The region code can only be changed 5 times, including the initial setting. Please be
aware that the fifth change becomes PERMANENT. Therefore, avoid changing the
region code unless absolutely necessary.
÷ Region codes are part of the DVD Standard. However, Region codes on DVD
discs are optional. DVD discs with no specified Region code can be played on all
players.
INTERFACE
FRONT VIEW
1 Forced Ejection Hole
If the tray fails to eject when the Eject button is pressed, insert a stiff rod into the hole and
push to eject the tray. During normal operation, the eject button should be used to unload the
tray. Make sure the power to the drive is turned off and wait at least one minute until the disc
stops spinning when forcing the tray to eject using the eject hole.
2 BUSY Indicator
Operation status is indicated as follows.
During reading Lights
During writing Lights
3 Eject Button (0)
To unload /load the disc, press the button.
4 Disc Tray
Open the loading tray by pressing the eject button, then place a CD or DVD disc onto the tray
with the label facing up.
Press the eject button or push the front tray panel to load the disc.
Do not attempt to pull out the disc tray forcibly.
Precautions on playing 8 cm (3.15") Discs
An 8 cm (3.15") disc cannot be played when the drive isverticaleven if an adapter is attached.