Filter
Top Products
Recording
06
62
En
Stereo recording and playback
VCR
The VHS Hi-Fi audio system permits high fidelity
recording of MTS STEREO TV broadcasts.
Note
• When playing back a video tape or disc that is not
recorded in Hi-Fi stereo mode, the audio will
automatically be monaural.
• When listening to a Hi-Fi video tape, disc or MTS
broadcast through the RF OUT (UHF/VHF) jack
(Audio/Video cord not connected), the sound will
be monaural.
When a MTS STEREO broadcast is received, the word
“STEREO” will appear on the screen and the program
can be viewed or recorded in stereo.
The Hi-Fi STEREO recording procedure is the same as
for normal recordings.
Note
• When using a CATV system, stereo TV programs
may be transmitted over a mono cable channel. In
this case the word “STEREO” will not appear and
the sound will be in mono.
Output selection
When viewing an MTS STEREO TV program, or playing a
prerecorded Hi-Fi STEREO on video tape or disc, press
AUDIO SELECT to select how the audio will be heard
through the speakers. Normally set to the Hi-Fi STEREO
position, this button can be set to the MONO position if
the stereo audio is of poor quality. The “R” and “L”
positions allow the audio from the Right or Left Hi-Fi
channel to be heard over both TV speakers. This button
has no effect when viewing a monaural audio program.
Each time when you press the button, output selection
display appears on the screen for several seconds. Refer
to the chart below.
OUTPUT
SELECTION
STEREO
L ch
R ch
MONO
SOUND HEARD ON
BOTH SPEAKERS
STEREO
LEFT CHANNEL AUDIO
RIGHT CHANNEL AUDIO
MONO
2D30901B_En_52_62 27/9/04, 17:5362