Filter
Top Products
PRV-LX1Guide
EDL Commands
Page 4 of 6
3.0 COMMAND STRUCTURE
To build your EDLs, apply the command structure demonstrated in the example shown in
Section 2. Each command is numbered and must be in consecutive order. When creating
your EDLs, use the structure outlined below.
Note: Time code is SMPTE Non-Drop or Drop Frame.
Definitions:
### – Entry Number
OP – Operation
PAR – Parameter
Each operation contains a starting Entry Number and an Operation Command. An Entry
Number consists of three sequential digits. An Operation Command uses three characters.
A third field containing a parameter may be required. Parameters can consist of multiple
parts. Although parameters are often a series of numbers and letters, it is unnecessary to
separate the characters by a space, tab or comma. However, for ease of reading, a space
may separate one parameter from the next.
Header:
The EDL command structure requires that a header must be the top of the list. The header
is as follows: PIONEER-DVDRec-EDL 001
3.1 DVD-RW Disc Initialization
Entry Operation Parameter
### INI
This command can only be used as the first entry in an EDL. It will be ignored if
the PRV-LX1 target is set for HDD. There are no parameters for the initialization
command.
3.2 In / Out Point Record
Entry Operation Parameter
### REC In Point, Out Point and Stop (or Pause)
In / out points are in the first parameter. The second parameter consists of either
STOP or PAUSE. If several In/Out recordings are present in the EDL, the last
In/Out recording must include STOP as the final recording operation.