Filter
Top Products
Indisys Management System: Setup and Operation 10
Installing PS5580 Displays on
VESA Mounts
Note: If you plan to use the Planar Mounting System for these displays, skip this whole
section and see the manual Planar PS5580 Planar Mounting System.
1
Connect all cables to the panel and hang it in the lower left corner of the wall.
Be sure the panel is level.
2 Connect all cables for another display panel, and hang this panel. Hang this to
the right of the first panel.
3 Where the corners meet along the bottom edge, slip an alignment guide over
the corner hardware on the back of the panels. The alignment guide should
not protrude beyond the exposed edges of the panels.
4 Check that both displays are level and straight.
5 Tighten the screws for this alignment guide, compressing the nylon spaces
until the guide is held in place.
6 Where the corners meet along the top edge, slip an alignment guide over the
corner hardware on the back of the panels. The alignment guide should not
protrude beyond the exposed edges of the panels.
Note: If there are multiple rows, the alignment guide should protrude beyond the edges
of the panels. However, if this is a one-row installation, they should not protrude.
7
Tighten all the screws for this alignment guide, compressing the nylon
washer.
8 Repeat steps 2-7 until the first row is complete.
Intermediate Rows
1 Attach all cables and hang the leftmost panel in this second row. The corner
hardware should mate with the protruding hardware from the row below.
2 Tighten the lower right corner screw so it holds the alignment guide.
3 Where the corners meet along the left edge, slip an alignment guide over the
corner hardware on the back of the panels. This guide should not protrude.
Tighten the screws for this guide.
4 Attach cables for the next panel and hang it as the next panel to the right in
this row. Be sure the corner hardware mates with the protruding hardware
next to it, and that everything is level and straight.