Filter
Top Products
- 14 -
System Connections
Connecting to TV Signal
This unit can be connected to the TV signal input source via the TV jack on the rear panel.
After connection, turn on the power of the unit, press the INPUT button to shift to TV mode.
After connecting to the antenna, turn on the unit, and go on with program searching, you can
follow the below steps to select channels:
1. For 0~9 channel:
Press the number buttons to select the channel X
, wait two seconds and it will go to the selected
channel.
Or press the number buttons to input 00X
, it will go to the selected channel immediately.
2. For 10~99 channel:
Press the number buttons to select channel XX
, wait two seconds and it will go to the selected
channel.
3. For 100~125 channels:
Press the number buttons to select channels XXX
, and it will go to the selected channel.
* X is the channel number.
When the unit is connected with CATV cable, after selecting the TV channel number including one or
two number, press the ENT button to confirm, after selecting the TV channel number (refer to three
number), don’t need to press the ENT button to confirm. When the unit is connected with external
antenna, after selecting the TV channel number (refer to one number), press the ENT button to
confirm. after selecting the TV channel number (refer to two number), don’t need to press the ENT
button to confirm.