PYLE Audio PSW503ST TV Mount User Manual


 
Hardware List: Actual parts appearance and the quantity may different
with illustrated.
Hardware List:
4
4
H
I
J
K
4
4
Square washer
Long bolt
Wall anchor
Long bolt washer
Spacer
ID Description
1
2
A
3
4
5
6
B
C
1
1
1
4
1
2
1
4
4
Wall mount
M4 mm×12 bolt
M4 mm×16 bolt
M5× mm16 bolt
M6×16mm bolt
M5×36mm bolt
M6×36mm bolt
Qty
D
4
4
4
4
E
F
G
Cable Cover
Safe bolt
Box wrench
After determining the height of stand, follow the installation instructions in below
to install wall mount to different kinds of wall
Using a awl or nail to make where the nails are located, as shown as Fig.3b. Distance
between two nails for fixing wall mount must not less than 16 . Slide the plate into
position as required.(Fig.3c) Pre-drill these holes with a 5mm drill bit to at least
40mm in deep hole. Use wall mount as a template to mark the location of other three
holes and drill the same holes.
Fixthewallmounttothewallwith4longbolts(H)andwashers(J) .
-wooden, brick, concrete and stone.
Please make sure these holes are level and eudipleural.
by box wrench(6)
Wooden wall:
Wooden wall:
-2-
-7-
A-F
J
G
I
H
K
ID
Description
Qty
Fig 3b Fig 3c
Brick, Concrete and Stone wall:
Using a awl or nail to make where the nails are located. Distance between two nails
for fixing wall mount must not less than 16 . Slide the plate into position as required.
(Fig.3c) Pre-drill these holes with a 10mm drill bit to at least 50mm in deep hole. Use
wall mount as a template to mark the location of other three holes and drill the same
holes. Please make sure these holes are level and eudipleural. Insert wall anchors(I)
into each of these holes. Attach the wall mount to the wall using 4 long bolts(H) and
washers(J)by box wrench(6).
Brick, Concrete and Stone wall:
1
2
5
3
4
Plate
Fig 3d
H
J
1
Balance-adjusting
Using balance-adjusting system on the plate,
make sure whether wall plate is installed
balance. If not, then slide the wall plate let
pointer level in the center position.
Left bracket
Right bracket
6
6