1) Insert a pre-recorded tape into the playing VCR.
2) Insert a tape with its record tab into the recording unit.
3) Press [SPEED] on the remote control of the recording unit to select the desired recording speed (SP/SLP).
4) Select the “L1”or “L2” position on the recording unit.
• To use the input jacks on the back of this unit, select “L1” position by pressing [0], [0], [1] on the remote control or
[CHANNEL
KK
/
LL
].
• To use the input jacks on the front of this unit, select “L2” position by pressing [0], [0], [2] on the remote control or
[CHANNEL
KK
/
LL
].
5) Press [REC/OTR] on the recording unit.
6) Begin playback of the tape in another source.
7) To stop recording, press [STOP/EJECT
CC
/
AA
] on the recording unit, then stop playback of the tape in another source.
Hint
Hint
• For best results during dubbing, use the front panel controls whenever possible. The remote control might affect another source’s operation.
• Always use video-quality shielded cables with RCA-type connectors. Standard Audio cables are not recommended.
• You can use a video disc player, satellite receiver or other Audio/Video component with Audio/Video outputs.
• “L1” or “L2” is found before the lowest memorized channel. (Example: CH02)
• “L2” input jacks are on the front of this unit.
Copying a Video Tape
1
1
- M E N U -
TIMER PROGRAMMING
AUTO REPEAT [OFF]
CHANNEL SET UP
CLOCK SET
LANGUAGE SELECT
B AUDIO OUT
TV STEREO [ON]
SAP
MTS System (Multi-Channel Television Sound)
2
2 To exit the menu
2
2
AUDIO OUT
B HIFI [ON]
MONO
Select “HIFI” or “MONO”.
When You Receive or Record a Program Broadcast in MTS
When You Play Back a Tape Recorded in Hi-Fi Stereo
•
When you receive a broadcast on the
VCR, you can check the type of the
broadcast by pressing [DISPLAY].
•
When “TV STEREO” or “SAP” selec-
tion is valid, select them by following
the steps below. This selection is
needed when you record the program.
•
SAP means Second Audio Program
(usually second language).
• If you have connected a stereo
TV to this unit, select “HIFI”.
• If you have connected a monaur-
al TV to this unit, select “MONO”.
C. RESET