RCA 27F671T Flat Panel Television User Manual


 
Chapter 3 23
Graphics contained within this publication are for representation only.
Using the TV’s Features
Why You Should Use the Auto Tuning Feature
The auto tuning feature automatically tunes the TV to the correct channel for different
components you have connected to your TV (like a VCR, DVD Player, etc.) When you set up
auto tuning in the menu system, you don’t have to remember to change your TV to
channel 3; for example, when you want to watch the tape in your VCR.
How to Set Up the Auto Tuning Feature
The way you set up the auto tuning feature in the TV’s menu corresponds to the
component buttons on the remote and the way you have each component connected to
your TV. When you set up auto tuning, you’re telling the TV what channel to tune to when
you press the VCR1, VCR2, DVD, or SAT•CABLE button on the remote control.
1. Press MENU (the MAIN MENU appears).
2. Highlight Setup and press OK on your remote control.
3. Highlight Auto Tuning and press OK.
4. Choose which channel you would like to set:
Set VCR1 The channel the TV tunes to when you press the VCR1 button.
Set VCR2 The channel the TV tunes to when you press the VCR2 button.
Set SAT/CABLE The channel the TV tunes to when you press the SAT•CABLE button.
Set DVD The channel the TV tunes to when you press the DVD button.
5. Press the right arrow button to select the choice that matches the way you have the
component connected to this TV, and press OK.
The choices and a brief explanation follow:
N/A Choose this if you don’t have this particular
component connected to the TV, or if you don’t want the TV
to automatically tune to the correct channel when you’re
using this component.
CH02 (SAT/CABLE only) Component is connected to the TV
ANT jack on the back of the TV, and you want the TV to tune
to channel 2 when you press the SAT•CABLE button on the
remote. Reminder: make sure the component’s Channel 2/3/4
switch is set to channel 2. Usually this switch is on the back
of the component.
CH03 or 04 Component is connected to the TV ANT jack on
the back of the TV, and you want the TV to tune to channel 3
or 4 when you press the corresponding button on the
remote. Reminder: make sure the component’s Channel 3/4
switch is set to the appropriate channel.
VID1 Component is connected to the VIDEO 1 VIDEO or
S-VIDEO jack on the back of the TV and you want the TV to
tune to a video input channel when you press the
corresponding button.
VID2 Component is connected to the VIDEO 2 VIDEO or Y,
Pb, Pr jacks on the back of the TV and you want the TV to
tune to a video or component video input channel when you
press the corresponding button.
Go Back
Set VCR1
Set VCR2
Set SAT/CABLE
Set DVD
AUTO TUNING
VID1 . . .
VID2 . . .
CH02 . . .
CH03 . . .
16356860.03-Features 4/28/04, 9:53 AM23