Filter
Top Products
Inserting
Batteries in the Remote
Remove the cover of battery cabin on the back of the remote control by lifting the cover
Insert two AAA batteries making sure the polarities (+ and ) are aligned correctly
Place the cover back
If the remote control does not work, check these points:
• Are the polarities (+) correct?
• Are the batteries worn out?
• Is there an AC power failure?
• Is the power cord plugged in?
• Is there any interference or block near the remote
control sensor?
CAUTION:
• Used batteries should be recycled
• Keep out of children's reach
• DO NOT use new and old batteries together
• Change both the batteries at the same time
• When not using the remote control for a long time
remove the batteries from the unit
Remote Control Reception Angle
Use your remote control within the distance and angle range shown below
7 meters
J
16