RCA D40W20 Flat Panel Television User Manual


 
Other Information
Chapter 5 27
Graphics contained within this publication are for representation only.
Sound okay, picture poor
Check antenna connections. Make sure all of the cables are firmly connected to the jacks.
Try adjusting sharpness function to improve weak signals. Go to page 23 for more instructions.
Volume buttons not adjusting volume louder
Check to make sure volume isnt limited by the maximum volume feature. Go to page 24 for more instructions.
Picture not moving
You have activated the Freeze feature by pressing OK on the remote. Press any button to unfreeze the picture.
Black box appears on the screen
Closed-captioning might be on. Check Closed Caption in the Setup menu. Go to page 25 for more instructions.
Freeze not working
The freeze feature is not available for Component video (CMP1 or CMP2) or DVI inputs.
Low battery warning appears on screen
Place new batteries in remote.
The Remote Control Doesnt Work
Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.
Maybe the remote isnt aimed directly at the component (TV or VCR) that youre trying to operate.
Maybe remote is not in TV Mode. Press the TV button so remote will control TV.
Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in the remote. (Note, if you remove the batteries, you may have to
reprogram the remote to operate other components.)
You might need to drain the remotes microprocessor: remove batteries and press the number 1 button for at least 60 seconds. Release the 1 button,
replace the batteries, and (if necessary) program the remote again.
Problems with V-Chip/Parental Controls
The rating limits dont work
You must lock the settings. Go to the MAIN MENU (press MENU on your remote), select Parental Control, select Lock Parental Controls.
I dont remember my password and I want to unlock the TV
If you forget your password, press MENU, then select Parental Control (the password entry screen appears). Simultaneously press and hold CH+ and VOL+
on the TVs front panel for 3 seconds. The Parental control menu appears on the screen, and you can re-enter a password via Lock Parental Controls.
The V-Chip wont let me watch a program even though its not rated as violent.
Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set NR to View separately in order to view movies with an
NR rating.
Care and Cleaning
CAUTION: Turn OFF your TV before cleaning.
You can clean the TV as required, using a soft lint-free cloth. Be sure to occasionally dust the ventilation slots in the cabinet to help assure adequate
ventilation.
The TVs screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen. If necessary, you may use a cloth
dampened with warm water. Never use strong cleaning agents, such as ammonia-based cleaners, or abrasive powder. These types of cleaners will
damage the TV.
While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV. Also, never place drinks or vases
with water on top of the TV. This could increase the risk of fire or shock hazard or damage to the TV.
Caution: Using video games or any external accessory with fixed images for extended periods of time can cause them to be permanently imprinted on
the picture tube (or projection TV picture tubes). ALSO, some network/program logos, phone numbers, etc. may cause similar damage. This damage is
not covered by your warranty.