Filter
Top Products
Chapter 3: Using USB Clone Tool
37Chapter 3
Learning - 22inch
R - AUDIO - L
AV2
VIDEO
USB IN
AUDIO IN
(RGB/DVI)
DIGITAL AUDIO
OUT(COAXIAL)
ANTENNA/
CABLE IN
SERVICE
Teaching
Learning
Rear panel of the set
2.5mm Stereo Cable
(cross data cable)
USB Cloner
Copying settings out of TV.
1. Turn TV on.
2. Connect USB Cloner to TV USB Port.
3. Set switch to “learning” position.
(Status LED will Light red without flashing.)
4. Connect 2.5mm Stereo Cable (cross data cable)
between the TV service port and the USB Cloner ser-
vice port.
5. Press the Learn button for 1 second. As soon as the
LED turns green, release the button.
6. The LED will turn Red and flash while the settings are
being saved to the USB Key. Upon successful copy, the
LED will light up yellow for 2 seconds and then return
to a red, constantly lit state. Upon an unsuccessful
copy, the LED will flash an error code as described in
the “Error Table” section.
Note :New TV Settings file, “ChList.bin” will appear on
the USB Cloner .
Learning - 26 inch
Copying settings out of TV.
1. Turn TV on.
2. Connect USB Cloner to TV USB Port.
3. Set switch to “learning” position.
(Status LED will Light red without flashing.)
4. Connect 2.5mm Stereo Cable (cross data cable)
between the TV service port and the USB Cloner ser-
vice port.
5. Press the Learn button for 1 second. As soon as the
LED turns green, release the button.
6. The LED will turn Red and flash while the settings are
being saved to the USB Key. Upon successful copy, the
LED will light up yellow for 2 seconds and then return
to a red, constantly lit state. Upon an unsuccessful
copy, the LED will flash an error code as described in
the “Error Table” section.
Note :New TV Settings file, “ChList.bin” will appear on
the USB Cloner .
R - AUDIO - L
AV2
VIDEO
USB IN
AUDIO IN
(RGB/DVI)
ANTENNA/
CABLE IN
SERVICE
AV1
AUDIO
L
VIDEO
R
Teaching
Learning
Rear panel of the set
Side panel
of the set
Side panel
of the set
2.5mm Stereo Cable
(cross data cable)
USB Cloner